Clamping Sleeves, Installing:
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Make sure that dimension -A- of 5.7 mm maximum is observed. Dimension -A- must never be greater than 5.7 mm, otherwise there may be leaks.
-- Insert a new clamping sleeve and tighten it with the :VAS6199 .
-- Align the tie rod so that tie rod ends pins are in the installation position.
-- Insert the tie rod into the wheel bearing housing all the way.
-- Install the wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Axle alignment is required. Refer to the table in EVALUATING NEED FOR AXLE ALIGNMENT .