Overview - Steering Gear, Electro-Mechanical Steering Gear: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Electro-Mechanical Steering Gear with Tie Rods
- With Power Steering Control Module -J500-
- Removing and Installing. Refer to STEERING GEAR, REMOVING AND INSTALLING, ELECTRO-MECHANICAL STEERING GEAR .
- Servicing. Refer to STEERING GEAR, SERVICING, ELECTRO-MECHANICAL STEERING GEAR .
- There are different versions. Refer to the
Parts Information.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and install on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.
- Bolt
- 80 Nm +180°
- Always replace if removed
- Subframe
- Nut
- Always replace if removed
- Pushed into the subframe
- Steering Intermediate Shaft
- Bolt
- Tightening specification -item ) OVERVIEW - STEERING COLUMN - Bolt.
- Wheel Bearing Housing
- Nut
- Always replace if removed
- There are different versions. Refer to the Parts Information. for the allocation.
- There are different versions and tightening specifications. Refer to OVERVIEW - STEERING GEAR, ELECTRO-MECHANICAL STEERING GEAR