LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1313 (STEERING (1 Of 2) (CABRIOLET)) >> 48 Steering >> Power Steering Hydraulics >> Overview - Power Steering Pump >> Overview - Power Steering Pump, 4-Cylinder TFSI, Without Dynamic Steering

Overview - Power Steering Pump, 4-Cylinder TFSI, Without Dynamic Steering

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Power Steering Pump, Removing and Installing, Vehicles with 4-Cylinder TFSI Engine and Vehicles without Dynamic Steering. Refer to REMOVING & INSTALLING POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CAEB, CPMA] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CAEB, CPMA] / POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CALA] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CALA] / POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CCBA, CGXC] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CCBA, CGXC] / POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CAUA, CFSA] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CAUA, CFSA] .

Power Steering Pump, without Dynamic Steering, Assembly Overview 

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Exploded View Of Power Steering Pump, Without Dynamic Steering (4-Cylinder TFSI)
GWWA48-10455Courtesy of AUDI OF AMERICA, LLC
  1. Bracket
  2. Sleeve
    • Drive the sleeve back slightly to install the power steering pump.
  3. Bolt
    • 25 Nm
  4. Bolt
    • 9 Nm
  5. Pressure Line
    CAUTION:
    • Insert the pressure line completely when installing.
  6. Seal
    • Always replace if removed
  7. Intake Hose
    • The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
  8. Clamp
    • Tension using Hose Clip Pliers:VAG1275A 
    • Always replace if removed
  9. Power Steering Pump
  10. Bolt
    • 25 Nm