LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1312 (STEERING (2 Of 2) (CABRIOLET)) >> 48 Steering >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Belt pulley to power steering pump bolt, 6-cylinder - 22
Electronic steering column lock control module to steering column bolt - 5
Handle to steering column bolt - 3
Power steering pressure line to steering gear bolt - 20
Power steering pressure line to rubber bushing nut - 6
Power steering pressure line union nut - 40
Power steering pressure line to power steering pump, union nut - 38
Power steering pressure line to power steering pump, bolt - 9
Power steering return line to steering gear bolt, without dynamic steering - 9
Power steering pump mounting bolt
- 4-cylinder TFSI and 8-cylinder FSI - 25
- 6-cylinder - 20
Reservoir to tension strap bolt - 9
Reservoir tension strap to body bolt - 9
Return line to body bolt - 9
Right knee bar to steering column bolt (2)
- Coupe - 20
- Cabriolet - 22
Rubber bushing to power steering gear - 6
Servotronic solenoid valve to steering gear bolt (3) - 3
Steering column mounting bolt - 20
Steering gear to subframe bolt (1) - 80 + 180°
Steering intermediate shaft to steering column bolt (1) - 30 + 90°
Steering intermediate shaft to steering gear bolt (1) - 30 + 90°
Steering wheel to steering column bolt (1)
- Coupe - 50
- Cabriolet - 30 + 90°
Tie rod to steering gear - 90
Tie rod end to tie rod nut - 60
Tie rod end to wheel bearing housing nut (1)
- Hex collar nut - 20 + 90°
- 12-point combi nut - 100
- Hex combi nut - 110
(1) Always replace after removal.
(2) Follow the assembly sequence when installing. Refer to Installing .
(3) Tighten in sequence. Refer to Servotronic Solenoid Valve -N119- .