Steering Intermediate Shaft, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

-- The threaded hole for the bolts must always be cleaned (for example, using a thread tap).

Tightening specifications, refer to STEERING COLUMN OVERVIEW .

-- Install the steering intermediate shaft.

-- Install the steering intermediate shaft -3- on the steering column -1- as far as the stop and tighten the bolt -2-.

Fig 1: Identifying Steering Intermediate Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the protective boot -2- as far as possible. Make sure, that the arrow -1- points upward.

Fig 2: Identifying Protective Boot Arrow

Courtesy of AUDI OF AMERICA, LLC

-- Pull the protective boot -1- through the opening.

Fig 3: Removing Protective Boot

Courtesy of AUDI OF AMERICA, LLC

-- Mount the protective boot -1-, without turning it, completely over the collar -2-.

-- Then check the installation position of the protective boot above the marking inside the passenger compartment. If necessary, loosen the protective boot and turn it to the correct installation position.

-- The mount the steering intermediate shaft -1- all the way onto the steering gear -2- and tighten the bolt -arrow-.

Fig 4: Locating Steering Intermediate Shaft Bolt

Courtesy of AUDI OF AMERICA, LLC

Further installation is in the reverse sequence to removal.