Power Steering Pump, Vehicles With Dynamic Steering [CCBA, CGXC]: Overview

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

Only use hydraulic oil.

Fig 1: Exploded View Of Power Steering Pump, Vehicles With Dynamic Steering (6-Cylinder FSI)

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 20 Nm
Clamp
- Tension using hose clamp pliers:V.A.G 1275 .
- Always replace if removed.
Intake Hose
- The marking "P" on the suction hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Power Steering Pump Control Valve -(V119)-
- The power steering pump and the control valve are one component and can only be replaced together.
Power Steering Pump -V119-
- With power steering pump control valve -(V119)-.
- The power steering pump and the control valve ) POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CCBA, CGXC] - POWER STEERING PUMP CONTROL VALVE -(V119)- are one component and can only be replaced together.
- Allocation Parts Information.
- Fill with hydraulic oil before installation.
- Checking delivery pressure. Refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE [CCBA, CGXC] .
- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering system, checking for leaks, refer to STEERING, CHECKING FOR LEAKS .
Seal
- Always replace if removed.
Union nut
- 38 Nm
- 36 Nm, this tightening specification applies only with the 17 mm ring spanner insert, open:V.A.G 1331/10 .
Pressure Line
CAUTION:
- Insert the pressure line completely when installing.
- Observe installation position: The angle between the line connection and power steering pump axle is approximately 59°
Bolt
- 22 Nm
Belt Pulley
Bolt
- 20 Nm
- For attaching the bracket to the engine.
- Note the different bolt lengths.
Bolt
- 20 Nm
- For attaching the bracket to the engine.
- Note the different bolt lengths.
Bolt
- 20 Nm
- For securing the power steering pump to the bracket.
Bolt
- 20 Nm
- For attaching the bracket to the engine.