Tie Rod: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The tie rods can be removed and installed with the steering gear in the vehicle.

-- Remove the front wheel. Refer to WHEEL, CHANGING AND MOUNTING .

-- Remove noise insulation NOISE INSULATION, REMOVING AND INSTALLING / OVERVIEW - NOISE INSULATION .

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2- and make a note of the value. Dimension -a- must be the same on the left and right sides after installing.

Fig 1: Measuring Tie Rod Head / Tie Rod Dimension

Courtesy of AUDI OF AMERICA, LLC

-- If necessary, shorten the "longer" tie rod head (installed it deeper into the tie rod).

-- Clean the power steering gear and subframe in the boot area.

CAUTION:

Dirt must not enter the power steering gear and boot when replacing the tie rod.

-- Open and remove the spring clip -3- using the :V.A.G 1921 .

Fig 2: Identifying Power Steering Gear Boot

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clamping sleeve -1- and remove the boot -3- outward from the power steering gear.

-- Remove the nut -1- from the tie rod end joint pin -2- until it is flush with the joint pin threads. Counterhold when loosening.

Fig 3: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To protect thread, screw nut on pin a few turns.

-- Press off track rod ball joint from wheel bearing housing using :T40010 A . Remove the nut.

Fig 4: Removing Tie Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

-- Remove tie rod. Counterhold at the power steering gear coupling rod with an open end wrench -1-.

Fig 5: Removing Tie Rod

Courtesy of AUDI OF AMERICA, LLC

2 - :V.A.G 1923