Boot Assembly

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Outer Boot Assembly Dimension -A-

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- 2 mm

-- Align tie rod so that tie rod ball joint pints are in installation location.

-- Insert the tie rod into the wheel bearing housing as far as the stop.

-- Install the front wheel. Refer to WHEEL, CHANGING AND MOUNTING .

-- An axle alignment may be required. Refer to WHEEL ALIGNMENT .

NOTE:

The wheel alignment must be performed on a VW/Audi approved alignment stand.