Reservoir Bracket To The Body: Notes

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Reservoir Bracket To Body

Courtesy of AUDI OF AMERICA, LLC

-- Secure the bracket -2- to the body with bolts -1-.

-- Secure the reservoir -4- in the bracket -2- using the bolt -3-.

Reservoir in the Bracket

Fig 2: Identifying Reservoir In Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Insert the reservoir with the tab -1- in the opening in the bracket -2-.

Hydraulic Oil Cooler to Condenser

Fig 3: Hydraulic Oil Cooler To Condenser

Courtesy of AUDI OF AMERICA, LLC

-- Position the hydraulic oil cooler -1- on the brackets -2- and then engage it into the brackets -3-.

Lines to the hydraulic oil cooler, refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Pressurized Line to Crossbrace

Fig 4: Identifying Pressurized Line To Crossbrace

Courtesy of AUDI OF AMERICA, LLC

-- Install the pressure line on the crossbrace using the nut -3- and rubber bushing -4-.

-- Note the line installation location when bolting the line connection. The markings -1- and -2- must be opposite each other.

Pressurized Line to the Engine Mount

Fig 5: Identifying Pressurized Line To Engine Mount

Courtesy of AUDI OF AMERICA, LLC

-- Route the pressure line -4- between the connector -2- and the engine mount -3-.

-- Tighten the retaining bracket -5- on the threaded pin -1- using the nut -6-.

Return Line Bracket to Longitudinal Member, Vehicles without Dynamic Steering

Fig 6: Identifying Return Line Bracket To Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Install the return line -1- on the longitudinal member threaded pins -2- using the clips -5-.

-- Install the return line -1- with the colored markings -arrows- in the clips -5-.

-- Secure the return line -1- with the line bracket -4- to the left front of the subframe -3-.

Return Line Bracket to Longitudinal Member, Vehicles with Dynamic Steering

Fig 7: Return Line Bracket To Longitudinal Member

Courtesy of AUDI OF AMERICA, LLC

-- Mount the return line plate -1- and nuts -2- onto the threaded pins on the longitudinal member and then tighten the nuts.

-- Secure the return line -1- and the line bracket -3- to the front of the subframe on the left side.