Instrument Panel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal and Note The Following:

WARNING:

Note the allocation of the airbag to the instrument panel. Refer to the Parts Information.

-- Set the instrument panel in place and guide the connectors for the Sunlight Photo Sensor -G107- and speakers through the openings in the instrument panel.

-- Check if there is a rubber buffer -3- on the clamp -2- on the lower windshield frame.

Fig 1: Check If There Is A Rubber Buffer -3- On Clamp -2- On Lower Windshield Frame

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- When sliding the instrument panel -1- on, make sure the clips engage in the box-shaped profiles on the bottom side of the instrument panel.

WARNING:

Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

NOTE:

Make sure the connectors are installed all the way and engage audibly.

-- Align the instrument panel and tighten the bolts.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.