Wheel Bearing Housing, All Wheel Drive (AWD), Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

Tightening Specifications. Refer to OVERVIEW - WHEEL BEARING, VEHICLES WITH ALL WHEEL DRIVE (AWD) .

NOTE:

Bonded Rubber Bushings Can Only Be Turned To A Limited Extent. Only Tighten Suspension Screws When Vehicle Is In Curb Weight Or Control Position.

Wheel Bearing, Lifting To Curb Weight Position On Vehicles With Coil Springs. Refer to WHEEL BEARING IN CURB WEIGHT, REAR AXLE, LIFTING VEHICLES WITH COIL SPRING .

-- Install wheel bearing housing.

-- Insert the bolt -1- with the spacer tube -2- and install the nut -3- loosely.

Fig 1: Bolt -1- And Spacer Tube -2- And Nut -3-

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Do not tighten the threaded connection using the nut -3-.

-- Tighten the bolt -1-.

-- Install the coil spring. Refer to SPRING, REMOVING AND INSTALLING .

-- Install the brake caliper and the brake rotor. Refer to REAR BRAKE CALIPER, REMOVING AND INSTALLING .

-- Install the Rear ABS Wheel Speed Sensor --. Refer to Sensors RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46-, REMOVING AND INSTALLING .

-- Install the wheel.

-- Tighten the wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Tighten the drive axle to wheel hub threaded connection. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

-- An axle alignment may be required. Refer to EVALUATING NEED FOR AXLE ALIGNMENT .

The Axle Alignment On The Front And Rear Axles Must Be Performed On A VW/Audi Approved Alignment Rack.