Drive Axle, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is the reverse of removal, with special attention to the following:

Drive Axle Tightening Specifications. Refer to OVERVIEW - DRIVE AXLE WITH OUTER CV JOINT WITH 88 MM DIAMETER AND INNER CV JOINT WITH 100 MM DIAMETER .

Drive Axle Tightening Specifications. Refer to OVERVIEW - DRIVE AXLE WITH OUTER CV JOINT WITH 100 MM DIAMETER AND INNER CV JOINT WITH 108 MM DIAMETER .

-- Install the rear final drive. Refer to OVERVIEW - FINAL DRIVE [0AW-FWD] or OVERVIEW - FINAL DRIVE [0AW] .

-- Install the rear muffler with brackets. Refer to OVERVIEW - MUFFLER [CAED, CAEB, CPMB, CPMA] .

-- Install The Fuel Tank Mounting Strap. Refer to OVERVIEW - FUEL TANK .

-- Install the coil spring. Refer to SPRING, REMOVING AND INSTALLING .

-- Install the Rear ABS Wheel Speed Sensor --. Refer to RIGHT/LEFT REAR ABS WHEEL SPEED SENSOR -G44- / -G46-, REMOVING AND INSTALLING .

-- Tighten the wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Tighten the drive axle to wheel hub threaded connection. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .