Wheel Bearing Unit: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove wheel bearing housing. Refer to WHEEL BEARING HOUSING .

-- Clamp the wheel bearing housing in a vise with protective covers.

-- Remove the bolts -1- and the wheel bearing unit -2-.

Fig 1: Bolts And Wheel Bearing Unit

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Avoid contaminating with dirt and damaging the seal when setting down/storing.

The wheel bearing -1- must face up in order to remove the wheel bearing unit.

Fig 2: Always Set Wheel Bearing Down On Wheel Hub -2- (Wheel Bearing -1- Faceing Up)
Courtesy of AUDI OF AMERICA, LLC
Always set the wheel bearing unit down on the wheel hub -2-.
Never reach into the inside when lifting the wheel bearing.

Fig 3: Correct & Incorrect Holding Of Wheel Bearing
Courtesy of AUDI OF AMERICA, LLC
Hold the wheel bearing only on the outside.

The same procedure also applies to the wheel bearing without a wheel hub.