LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (Hydraulic Components - Brake System (Cabriolet)) >> 47 Hydraulic Components >> Vacuum System >> Check Valve, Removing And Installing >> Check Valve, Removing And Installing, Except RS 5 >> Installing

Check Valve, Removing And Installing, Except RS 5: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Make sure the check valve is installed correctly. The arrow on the valve points in the direction of the pump.

Valve must allow air to flow in direction of arrow.

the arrow indicates the direction of the vacuum pump.

-- Slide the vacuum hose on the left and right onto the check valve -4-.

NOTE:

For easier installation, moisten the vacuum hose with water.

-- Slide the new clamp over the vacuum hose.

-- Slide the vacuum hose onto the pump.

-- Close the hose clamp with pliers.