Brake Booster Pressure Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover. Refer to BULKHEAD .
NOTE:
The Brake Booster Pressure Sensor -G294- is located in the plenum chamber near the brake booster.
-- Disconnect the connector -1-.
-- Remove the pressure sensor in the direction of the -arrow-.
NOTE:
The pressure sensor is secured with clips.
-- Release the clips with pliers -1-.
-- Carefully pry off the Brake Booster Pressure Sensor -G294-.