Overview - Front Brake Caliper, FBC, 1LA And 1LJ Brake Caliper
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Install The Entire Repair Kit When Servicing.
Apply a thin coat of Assembly Paste:G 052 150 A2 to brake cylinders, pistons and seals.
- Bolt
- 30 Nm
- Protective Cap
- Insert in brake caliper
- Replace. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Guide Pin
- Slide through the boot
- Replace. Refer to BEARING BUSHING AND GUIDE PIN, REPLACING, FBC, 1LA AND 1LJ BRAKE CALIPER .
- Protective Cap
- Install on the bleeder valve.
- Breather Valve
- 15 Nm
- Apply a thin coat of Assembly Paste: G 052 150 A2 to the threads before screwing in.
- Brake Caliper Housing
- Spring
- ensure installation position is correct.
- Protective Cap
- Do not damage when inserting the piston
- Coat with Assembly Paste: G 052 150 A2 .
- PROTECTIVE CAP AND SEAL, REMOVING
- Piston
- Apply a thin coat of Assembly Paste:G 052 150 A2 to the piston beforehand
- Diameter 57 mm.
- PROTECTIVE CAP AND SEAL, REMOVING
- Seal
- Coat with Assembly Paste: G 052 150 A2 .
- Refer to PROTECTIVE CAP AND SEAL, REMOVING
- Brake Carrier
- Removing and installing. Refer to BRAKE CALIPER, REMOVING AND INSTALLING, 1LA, 1LB, 1LJ AND 1LD 1ZT + S4 /S5 .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- Bolt
- 196 Nm