Brake Fluid Reservoir, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Remove the protective cap on the new brake fluid reservoir just before filling it.

-- Coat the plugs on the brake fluid reservoir with brake fluid.

-- Insert the brake fluid reservoir in the sealing plugs in the brake master cylinder.

-- Push the lower locking pin through the brake fluid reservoir.

-- Connect the connector for the Brake Fluid Level Warning Switch -F34-.

-- With manual transmission, connect the clutch hydraulic line -5- to the brake fluid reservoir.

Fig 1: Identifying Brake Master Cylinder Components

Courtesy of AUDI OF AMERICA, LLC

-- Fill the brake fluid up to the marking.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- For manual vehicles, bleed the clutch. Refer to appropriate service information. .

-- Install the brake fluid reservoir cover over the brake fluid reservoir.

NOTE:

The brake fluid reservoir cover is not installed on all vehicle models.

-- Install the plenum chamber cover. Refer to BULKHEAD .