Brake Booster, Removing And Installing: Installing: Notes

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert the brake booster in the vehicle.

Make sure the seal is seated correctly.

-- Install the bolts from the brake booster -1- to the mounting bracket and tighten them.

Fig 1: Brake Booster Bolts, Brake Lines & Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Press the vacuum line -3- into the brake booster.

Fig 2: Identifying Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake master cylinder. Refer to BRAKE MASTER CYLINDER, REMOVING AND INSTALLING .

-- Install the brake fluid reservoir. Refer to BRAKE FLUID RESERVOIR, REMOVING AND INSTALLING .

-- With manual transmissions, insert the clutch hydraulic line -5- into the brake fluid reservoir.

Fig 3: Identifying Brake Master Cylinder Components

Courtesy of AUDI OF AMERICA, LLC

-- Fill the brake fluid up to the marking.

-- Bleed the brake system. Refer to HYDRAULIC SYSTEM .

-- For manual vehicles, bleed the clutch. Refer to CLUTCH, SERVICING .

-- Install the plenum chamber bulkhead. Refer to BULKHEAD .

-- Install the tower brace. Refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Install the engine cover.

-- Install the plenum chamber cover. Refer to BULKHEAD .