Brake Shield, Removing And Installing, Vehicles With Fwd: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the wheel bearing housing. Refer to WHEEL BEARING HOUSING [CABRIOLET] (2 Of 2) / WHEEL BEARING HOUSING, REMOVING AND INSTALLING [CABRIOLET] (1 Of 2) .

-- Install the rear brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure that the brake hose is clipped in and mounted correctly on the combination bracket on the stub axle carrier. This is so that the brake hose does not jump out of the bracket by itself.

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL, CHANGING AND MOUNTING / WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower The Vehicle.