Brake Rotor, Replacing, 1LT And 1LY: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Clean Bolts Before Reusing

Replace Damaged Bolts

Always replace self-locking bolts.

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the wheel hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -arrow- and tighten.

Fig 1: Identifying Brake Disc Secure Bolt

Courtesy of AUDI OF AMERICA, LLC

-- Position the front brake carrier.

Fig 2: Identifying Brake Caliper Components

Courtesy of AUDI OF AMERICA, LLC

-- Install the bolts -5- on the front brake carrier and tighten.

-- Install the front brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, 1LT AND 1LY .

NOTE:

After replacing the brake pads, press the brake pedal firmly several times while the vehicle is stationary so that the brake pads are seated properly in their normal operating position.

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .