LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1300 (Seat Upholstery, Covers) >> 74 Seat Upholstery, Covers >> Front Seat Covers And Cushions >> Seat Cover And Cushion, Removing And Installing >> Removing

Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the seat. Refer to SEAT, REMOVING AND INSTALLING .

-- Remove the seat belt latch. Refer to FRONT SEAT BELT LATCHES, REMOVING AND INSTALLING .

-- Remove the tunnel-side trim. Refer to TUNNEL-SIDE TRIM, REMOVING AND INSTALLING .

-- Remove the sill-side trim. Refer to SILL-SIDE TRIM, REMOVING AND INSTALLING .

-- Remove the drawer. Refer to DRAWER, REMOVING AND INSTALLING .

-- Remove the bracket for the sill-side trim. Refer to SILL-SIDE TRIM BRACKET, REMOVING AND INSTALLING .

-- Remove the seat height adjustment operating lever for vehicles with manual seat height adjustment, refer toMANUAL SEAT HEIGHT ADJUSTMENT LEVER, REMOVING AND INSTALLING .

-- Unclip the 2 clip connections -arrows- on the bottom of the seat frame.

Fig 1: Uncoupling 2 Clip Connections -Arrows- From Bottom Of Seat Frame
GWWN74-10233Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Detach the front and side profiles -arrows- of the cover from the seat frame.

Fig 2: Identifying Front And Side Profiles -Arrows-
GWWN72-10413Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Detach the 2 profiles on the left side.

-- Detach the rear profile -1- from the mount in the seat frame.

Fig 3: Detaching Rear Profile -1- From Mount In Seat Frame
GWWN74-10234Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- In vehicles with a seat heater, pay attention to the routing of the wiring harness -2- .

Fig 4: Identifying Rear Edge Of Cushion -1-, Tension Straps -2- And Cover -3-
GWWN74-10235Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the cover and the cushion from the seat frame.

-- Detach the rear edge of the cushion -1- from the cover.

-- Pull the tension straps -2- off of the cushion.

-- Roll up the cover -3- on the sides.

-- In the front vertical cushion channels, cut each upholstery clip and roll up the profile -1- with the cover.

Fig 5: Identifying Profile -1- Of Cover
GWWN74-10236Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Cut the upholstery clips in the cushion channel -arrows- and detach the cover from the cushion.

Fig 6: Identifying Removal/Installation Of Cover Profiles With Upholstery Clips
GWWN74-10237Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Cut the remaining upholstery clips.