Right Cylinder Head Cover, Removing And Installing: Installing:

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications. Refer to Figure.

Install in reverse order of removal while noting the following:

NOTE:

Replace the O-ring.

If the cylinder head cover gasket is damaged, replace it.

Replace the cylinder head cover bolts when replacing the damaged seal.

-- Clean the sealing surfaces; they must be free of oil and grease.

-- Tighten the right cylinder head cover bolts. Refer to Figure.

-- Install the ignition coils. Refer to Ignition Coils with Power Output Stages --, REMOVING AND INSTALLING .