Overview - Balance Shaft And Oil Pump Drive Chain
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft
- Drive Chain
- For power take-off
- Mark the running direction with paint for reinstallation
- Removing and installing. Refer to DRIVE CHAIN BALANCE SHAFT, REMOVING AND INSTALLING .
- Drive Chain Sprocket
- For the oil pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm +90°
- Replace
- Pressure Spring
- Bolt
- 15 Nm +90°
- Replace
- Balance Shaft Chain Sprocket
- Installed position: the side with lettering on it faces the transmission
- Chain Tensioner
- With glide rail
- Bolt
- 10 Nm +45°
- Replace