Cylinder Head, Removing And Installing: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Cylinder head can only be removed with engine removed. Refer to ENGINE, REMOVING AND INSTALLING .
Special Tools And Workshop Equipment Required
- Camshaft Bar:T10068A
- Shop Crane - Drip Tray:VAS6208
- Shop Crane:VAS6100
- Lifting Tackle:3033
- Spring Clip Pliers: VAS6499
- Puller - Ignition Coil: T10095A
- Torque Wrench 1331 5-50Nm:VAG1331
- Torque Wrench 1332 40-200Nm:VAG1332
- Sealant:D 176 501 A1
- Locking Fluid: D 197 300 A2
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Cylinder head
- Bolts - Camshaft adjusters
- Bolts - Control housing
- Seal - Chain tensioner
- O-rings - Coolant connection
- Gasket - Cylinder head
Requirements
- Engine must be removed.