Electro-Drive Drive Motor -V141-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the Electro-Drive Drive Motor -V141-. .
-- Restart the high voltage system and complete the required documentation. Refer to RESTARTING THE HIGH VOLTAGE ELECTRICAL SYSTEM .
NOTE:
The Electro-Drive Drive Motor -V141- will automatically calibrate at the end of "Guided Fault Finding" once all Diagnostic Trouble Code (DTC) entries are erased.
The "calibration" must be performed each time the DTC memory for the Electric Drive Power and Control Electronics -JX1-, Battery Regulation Control Module -J840-, engine or transmission is "erased". Otherwise the vehicle will only start after the second try.