Overview - Supercharger
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Lifting Eye
- Bolt
- 27 Nm
- Supercharger
- With charge air coolers
- Supercharger, Removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Overview - Charge Air Cooler. Refer to OVERVIEW - CHARGE AIR COOLER .
- Removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Secured on the Engine and Gearbox Bracket:VAS6095A for repair work. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR REPAIR WORK .
- Secured on the Engine and Gearbox Bracket:VAS6095A for leak test. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAK TEST .
- Insulation Plate
- Bolt
- 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- 10 Nm
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Connection
- Bolt
- 10 Nm
- Bracket
- For change-over valves
- Bolt
- 9 Nm
- Bolt
- 10 Nm
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing. Refer to Regulating Flap Control Unit -J808-, REMOVING AND INSTALLING .
- Bleeder Valve
- 1.5 to 3.0 Nm
- For the left charge air cooler
- Bolt
- 10 Nm
- Replace
- Self-locking
- Always clean the threaded holes with a thread tap before assembling
- Intake Air Temperature Sensor -G42-
- O-Rings
- Replace
- Nut
- 20 Nm
- O-Ring
- Replace
- Threaded Pin
- 17 Nm
- Bolt
- 10 Nm
- Replace
- Self-locking
- Always clean the threaded holes with a thread tap before assembling
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-, cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to CHARGE AIR PRESSURE SENSORS - G31- AND - G447-, REMOVING AND INSTALLING .
- Seals
- Replace
- O-Ring
- Replace
- Connection
- For the crankcase ventilation
- Installed position. Refer to Figure
- O-Rings
- Replace