Front Passenger Side Airbag Crash Sensor -G180-, Removing And Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Front Passenger Side Airbag Crash Sensor -G180- is installed on the door subframe.

WARNING:

Follow the General Safety Precautions when working with airbags, belt tensioners and battery cut-out units (pyrotechnic components). Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, GENERAL SAFETY PRECAUTIONS .

-- Disconnect the battery. Refer to BATTERY .

-- Remove the front door trim panel. Refer to FRONT DOOR TRIM, REMOVING AND INSTALLING .

Removing and installing the Front Passenger Side Airbag Crash Sensor -G180- is identical to removing and installing the Driver Side Airbag Crash Sensor -G179- and the same directions can be used:

Driver Side Airbag Crash Sensor -G179-, Removing and Installing. Refer to Driver Side Airbag Crash Sensor -G179-, REMOVING AND INSTALLING .