Side Panel Led Tail Lamps, Removing And Installing: Removing
-- Turn off the ignition and all electrical consumers and remove the key.
For Left Tail Lamp Assembly Inside the Side Panel
-- Depending on the equipment level, either remove the interior lamp inside the luggage compartment on the left side or unclip the cap -arrow- from the side trim panel.
For Right Tail Lamp Assembly Inside the Side Panel
-- Unclip the trim -1- from the trim panel inside the luggage compartment on the right side.
Continuation for All Vehicles
-- Remove the plastic bolt (11 mm) -arrow-.
The plastic screw is not secure.
Be careful so that the plastic screw does not fall behind the trim panel inside the luggage compartment.
-- Pull the tail lamp assembly to the rear and out of the opening in the body. Pay attention to the wires still connected.
-- Disconnect the connector -1- and remove the tail lamp assembly.