LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1231 (Exterior Lights, Switches) >> 94 Exterior Lights, Switches >> Led Tail Lamps >> General Information

General Information

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

The tail lamps (tail, turn signal, brake and backup lamps) cannot be disassembled other than the turn signal and back-up lamps. The turn signal and back-up lamp are generated by one light bulb, which cannot be replaced individually. The remaining lighting is provided by Light-Emitting Diodes (LEDs). Malfunctioning LEDs cannot be replaced.

Depending on market requirements, the tail lamps contain the following components and have the following functions:

NOTE:

Faulty tail lamp LED:

If a single LED is faulty, the entire lamp shuts down and must be replaced.

Additional Information:

Refer to the Owner's Manual.

Refer to the Wiring Diagram(s).

Malfunction Recognition And Malfunction Indicator

Comfort System and Vehicle Electrical System are equipped with On Board Diagnostics (OBD) which assists troubleshooting of tail light assemblies.

The "Guided Fault Finding"  function is to be used for troubleshooting of one of the systems described as in service information "Vehicle Diagnosis, Testing and Information System". Refer to VEHICLE DIAGNOSTIC TESTER .