Headlamps, Right Hand Drive Traffic, Converting To Left
The headlamp retrofit set consists of two foils.
The headlamp conversion kits for converting from RHD to LHD or from LHD to RHD have different part numbers.
Clean the headlamp glass. After removing the assembly foil, remove any adhesive residue on the glass. Remove the remaining adhesive only with an alcohol based cleaning solution or with a mixed alcohol and water based cleaning solution.
-- Turn the light switch to position "0".
Left Headlamp:
-- Peel back the plastic protection -C- only in area -D-.
-- Lineup the film -C- with the lines -A- on the top and bottom edges of the headlamp glass.
-- At the same time line up the film -C- with the line -B- on the outer edge of the headlamp glass.
-- Press on the headlamp glass in area -D-.
-- Carefully remove the assembly foil -C- from the headlamp lens.
-- The cover foil -D- remains on the headlamp lens.
Right Headlamp:
-- Peel back the plastic protection -C- only in area -D-.
-- Lineup the film -C- with the lines -A- on the top and bottom edges of the headlamp glass.
-- At the same time line up the film -C- with the line -B- on the outer edge of the headlamp glass.
-- Press on the headlamp glass in area -D-.
-- Carefully remove the assembly foil -C- from the headlamp lens.
-- The cover foil -D- remains on the headlamp lens.
- Danger of the damaging the plastic.
- Using cleaners containing solvents can damage a plastic headlamp lens.
- Use only a cleaner with alcohol or an alcohol/water mix (isopropyl) to remove glue from the plastic headlamp lens.
Remove excess adhesive residue only with cleaning agents with an alcohol- or alcohol/water base. For example, a cloth moistened with isopropyl alcohol.
Share corresponding notes with the customer about removing adhesive residue after removing covers.