Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- Or Transmission Fluid Auxiliary Hydraulic Pump 2 -V476-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the noise insulation for the transmission.

-- Place the :SMN372500 underneath.

-- Remove ATF check plug -A-.

-- Remove the overflow pipe -C-.

Fig 1: Identifying Overflow Tube, Check Plug And Sealing Ring

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Drain the ATF.

Approximately 3.5-4 liters (3.7-4.2 quarts) will drain out.

-- Install the overflow tube -C- and tighten it to 2 Nm.

-- Tighten the ATF check plug -A- and new gasket -B- by hand.

NOTE:

Before removing, cover the area around the auxiliary hydraulic pump with several rags.

-- Disconnect the connector -A- and remove the auxiliary hydraulic pump bolts -1-.

Fig 2: Disconnect The Connector -A- And Remove The Auxiliary Hydraulic Pump Bolts -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening Specification: 32 Nm

-- Remove the auxiliary hydraulic pump.