Overview - Cylinder Head: Notes
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Illustration Shows The Cylinder Bank 2 Cylinder Head (Left) .
- Cylinder Head Gasket
- Replacing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Installed position: the part number faces the cylinder head
- Change the coolant and engine oil after replacing
- Cylinder Head
- Removing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Refer to Figure
- Refer to Figure
- Installing. Refer to INSTALLING .
- Change the coolant and engine oil after replacing
- Bolt
- Tightening Specification. Refer to VACUUM PUMP .
- Vacuum Pump
- Removing and installing. Refer to VACUUM PUMP .
- O-Ring
- Replace
- Bolt
- 20 Nm
- Engine Lifting Eye
- Camshaft Position Sensor, Intake Camshaft
- Cylinder bank 1 (right) Camshaft Position Sensor -G40-
- Cylinder bank 2 (left) Camshaft Position Sensor 2 -G163-
- Bolt
- 9 Nm
- Bolt
- Loosening procedure. Refer to REMOVING
- Replace
- Loosening procedure. Refer to INSTALLING
- Tighten in 3 stages:
-- Tighten to 40 Nm
-- Tighten an additional 90°
-- Tighten an additional 90°
- Ignition Coil
- Remove with Puller - Ignition Coil:T40039
- Cylinder Head Cover
- Removing and Installing: left. Refer to LEFT CYLINDER HEAD COVER, REMOVING AND INSTALLING , right refer to RIGHT CYLINDER HEAD COVER, REMOVING AND INSTALLING
- Seal
- Replace if damaged or leaking
- Cap
- Bolt
- Bolt
- Tightening Specification. Refer to TIGHTENING SPECIFICATION [IGNITION COILS] .
- Connector Strip
- For the ignition coils
- Cylinder Head Cover Gasket
- Replace if damaged or leaking
- Bolt
- 2.5 Nm
- Insert with sealant.
- Solenoid Valve for Camshaft Adjustment - Exhaust Side
- Cylinder bank 1 (right) Exhaust Camshaft Control Valve 1 -N318-
- Cylinder bank 2 (left) Exhaust Camshaft Adjustment Valve 2 -N319-
- Solenoid Valve for Camshaft Adjustment - Intake Side
- Cylinder bank 1 (right) Camshaft Adjustment Valve 1 -N205-
- Cylinder bank 2 (left) Camshaft Adjustment Valve 2 -N208-
- O-Rings
- Replace
- O-Ring
- Replace
- Bolt
- 9 Nm
- Camshaft Position Sensor, Exhaust Camshaft
- Cylinder bank 1 (right) Camshaft Position Sensor 3 -G300-
- Cylinder bank 2 (left) Camshaft Position Sensor 4 -G301-