Continuation For Both Cylinder Heads:

Fig 1: Identifying Bolts At Rear Of Cylinder Head

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -arrows-.

• Left cylinder head: 3 bolts.
• Right cylinder head: 4 bolts

Install In Reverse Order Of Removal. Note The Following: 

-- Install oil dipstick guide tube. Refer to Figure.

-- Position the camshaft timing chain on the camshafts. Refer to Installing .

-- Install the cylinder head cover. For the left side. Refer to LEFT CYLINDER HEAD COVER, REMOVING AND INSTALLING  and for the right side refer to RIGHT CYLINDER HEAD COVER, REMOVING AND INSTALLING .

-- Install front coolant pipe. Refer to FRONT COOLANT PIPES, REMOVING AND INSTALLING .

-- Install the power steering pump. Refer to OVERVIEW - POWER STEERING PUMP .

-- Install the left catalytic converter: for vehicles with manual transmissions. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING . For vehicles with the multitronic 0AW or automatic transmission 0B6. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the right catalytic converter: for vehicles with manual transmissions/manual transmission 0AW. Refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING . For vehicles with the automatic transmission 0B6 or automatic transmission 0B6. Refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead. Refer to BULKHEAD .

-- Install the high pressure line, fuel supply line and the lower section of the intake manifold. Refer to OVERVIEW - INTAKE MANIFOLD LOWER SECTION WITH FUEL RAIL .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the upper coolant pipe. Refer to UPPER COOLANT PIPES, REMOVING AND INSTALLING .

-- Change the engine oil. Refer to appropriate service information.

-- Replace the coolant. Refer to COOLANT, DRAINING AND FILLING .