Wheel Bearing Unit, Front Wheel Drive (Fwd), Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a hoist.

-- Loosen the dust cap by lightly tapping on the :VW637/2 .

Fig 1: Identifying Hammer And Grease Cap Puller VW 637/2

Courtesy of AUDI OF AMERICA, LLC

-- Pry the dust cap with the :VW637/2 .

Fig 2: Identifying Grease Cap Puller VW 637/2 To Pull Off Dust Cap

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the wheel bearing unit collar bolt, but only when the vehicle is resting on its wheels. Refer To DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .

-- Remove the wheel.

-- Remove the brake caliper and the brake rotor. Refer To REAR BRAKES .

-- Secure the brake caliper to the body so that the weight of the caliper does not stress or damage the brake hose or brake line.

-- Remove the bolts -1- from the brake shield -2-.

Fig 3: Bolts -1- And Cover Plate -2-

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Do not pull the wheel bearing off by the outer race (wheel hub).

-- Remove the wheel bearing unit -2- over the brake shield -1- and from the stub axle -3-.

Fig 4: Identifying Wheel Bearing Unit Over Brake Shield And From Stub Axle

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If The Wheel Bearing Unit Can Be Removed From The Wheel Bearing Housing By Hand, The Wheel Bearing Unit Is OK And Can Be Reinstalled.

-- Reach behind the front seal -arrow- when the stub axle has been freed up enough. Remove the wheel bearing unit and the brake shield (both not shown in the illustration) over the front seal -arrow-.

Fig 5: Front Seal

Courtesy of AUDI OF AMERICA, LLC

Fig 6: Always Set Wheel Bearing Down On Wheel Hub -2- (Wheel Bearing -1- Facing Up)

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Avoid contaminating with dirt and damaging the seal when setting down/storing.

The wheel bearing -1- must always face up.
Always set the wheel bearing unit down on the wheel hub -2-.

-- Clean the front seal.