Installing A Clamp On The Inner Joint And Clamping

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Attaching CV Joint Boot Clamp Tool VAG 1682

Courtesy of AUDI OF AMERICA, LLC

-- Attach the :VAG1682A as illustrated. Make sure that the jaws of the tension clamp seat in the corners -arrows B- of the connecting tube.

-- Tighten the clamp by turning the spindle using a torque wrench -C- (do not tilt the pliers).

The hard material of the CV boot (compared to rubber) makes it necessary to use a stainless steel hose clamp. It is only possible to tighten the hose clamp with :VAG1682A .
Tightening Specification: 20 Nm.
Use torque wrench with 5 to 50 Nm range (for example, :VAG1331 ).
make sure the spindle threads on the pliers -A- move freely. Grease with MoS₂ grease if necessary.
If the thread is tight, for example, dirty, the required tensioning force for the hose clamp will not be achieved in spite of correct torque specification settings.