Camshaft Guide Frame Tightening Specifications And Sequence

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bearing Frame Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

-- Tighten The Bolts In Three Steps And In The Sequence Shown:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 24-	Install All The Way In By Hand. The Guide Frame Must Touch The Entire Contact Surface On The Cylinder Head.
2.	-1 to 24-	8 Nm
3.	-1 to 24-	Tighten An Additional 90°