Overview - Cylinder Head: Notes

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Illustration Shows The Cylinder Bank 2 Cylinder Head (Left).

Fig 1: Exploded View Of Cylinder Head

Courtesy of AUDI OF AMERICA, LLC

Cylinder Head Gasket
- Replacing. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
- Installed Position: Parts Number To Cylinder Head
- Change The Coolant And Engine Oil After Replacing
Cylinder Head
- Removing And Installing. Refer To CYLINDER HEAD, REMOVING AND INSTALLING .
- Check For Distortion. Refer To Figure
- Reworking Dimension. Refer To Figure
- Change The Coolant And Engine Oil After Replacing
Seal
- For The Cylinder Head Cover
- Replace If Damaged Or Leaking
Cylinder Head Cover
- Removing And Installing. Refer To CYLINDER HEAD COVER, REMOVING AND INSTALLING .
Seal
- For The Cap
- Replace If Damaged Or Leaking
Cap
Ignition Coil
- Removing. Refer To IGNITION COILS, REMOVING AND INSTALLING .
Bolt
- Replace if the seal is damaged
- Tightening Specifications And Sequence: Left Cylinder Head Cover. Refer To Figure, Right Cylinder Head Cover. Refer To Figure
Camshaft Adjustment Valve 2 -N208-
Bolt
- 2.4 Nm
O-Ring
- Replacing
Seal
- Replacing
Sealing Plug
- 45 Nm
Bolt
- 2.4 Nm
Exhaust Camshaft Adjustment Valve 2 -N318-
O-Ring
- Replacing
Bolt
- Replacing
- Loosening Sequence. Refer To LOOSEN THE CYLINDER HEAD BOLTS IN THE SEQUENCE -1 TO 10-.
- Tightening Specification And Sequence. Refer To Figure.