Cylinder Head - Tightening Specification And Sequence
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace Any Bolts That Were Tightened With An Additional Turn.
-- Tighten The Bolts In Seven Stages In The Sequence Shown.
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 10- | Install all the way in by hand. |
| 2. | -1 through 10- | 30 Nm |
| 3. | -1 through 10- | 60 Nm |
| 4. | -1 through 10- | Tighten an additional 90° |
| 5. | -1 through 10- | Tighten an additional 90° |
| 6. | -Arrows- | Install using locking fluid, 11 Nm for the correct locking fluid. |
| 7. | -Arrows- | Tighten an additional 90° |