Tightening Specifications

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Figure.
Refer to Figure.

NOTE:

Replace The O-Ring.

Replace The Cylinder Head Seal If It Is Damaged.

Replace The Cylinder Head Cover Bolts When Replacing The Damaged Seal.

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

-- Clean The Sealing Surfaces; They Must Be Free Of Oil And Grease.

-- Tighten The Left Cylinder Head Cover Bolts. Refer To Figure.

Fig 1: Identifying Left Cylinder Head Cover Bolts Removal Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Tighten The Right Cylinder Head Cover Bolts. Refer To Figure.

Fig 2: Identifying Right Cylinder Head Cover Bolts Removal Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Install The Ignition Coils. Refer To IGNITION COILS, REMOVING AND INSTALLING .