Right Camshaft Timing Chain
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- Mounting Pin
- For The Right Camshaft Timing Chain Drive Sprocket
- Asymmetrical Version
- Installed Position. Refer To Figure
- Bolt
- 42 Nm
- Camshaft Adjuster
- For The Exhaust Camshaft
- Designation "EX"
- Removing And Installing. Refer To CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Bolt
- 80 Nm +90° turn
- Replacing
- Bolt
- 80 Nm +90° turn
- Replacing
- Camshaft Adjuster
- For The Intake Camshaft
- Designation "IN"
- Removing And Installing. Refer To CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Right Camshaft Timing Chain
- Remove From The Camshafts. Refer To CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .
- Before Removing, Mark The Direction Of Rotation With Paint
- Removing And Installing. Refer To CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Chain Tensioner
- For The Right Camshaft Timing Chain
- Illustration Does Not Correspond To Version In Vehicle
- Removing And Installing. Refer To CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Glide
- Oil Screen
- Set Into The Chain Tensioner
- Installed Position: Observe Locating Tabs On Circumference
- Seal
- Replacing
- Clipped Onto The Chain Tensioner
- Bolt
- 5 Nm +90° turn
- Replacing
- Thrust Washer
- For The Drive Chain Sprocket
- Drive Chain Sprocket
- For The Right Camshaft Timing Chain