Vibration Damper, Tightening Specification And Sequence
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make Sure The Alignment Sleeve Is Installed Inside The Vibration Damper. Install any missing alignment sleeves.
Replace any bolts that were tightened with an additional turn.
-- Tighten The Bolts In 3 Steps As Follows:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -arrow- | 15 Nm diagonally |
| 2. | -arrow- | 22 Nm diagonally |
| 3. | -arrow- | In a diagonal sequence, turn an additional 90° |