Crankshaft, Measuring Radial Clearance: Procedure
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove The Guide Frame And Clean The Bearing Journals.
-- Place The Plastigage® Over The Entire Width Of The Bearing Journal Or Into The Bearing Shells.
- Plastigage® must rest in center of bearing shell.
-- Position The Guide Frame And Tighten It To 30 Nm Without Tightening It Further ; Do Not Turn The Crankshaft.
-- Install The Guide Frame.
-- Compare Width Of Plastigage® With Calibrated Scale.
Radial Clearance:
- New: 0.017 to 0.044 mm.
- Wear limit: 0.08 mm.