Overview - Cylinder Block, Belt Pulley Side, Hybrid Vehicles
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 150 Nm + 90°
- Always replace after removing
- Lubricate the O-ring
- O-ring
- Not a replacement part; supplied with the bolt
- Vibration Damper
- With the ribbed belt pulley
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING
- Sub-Assembly Bracket
- With oil filter and engine oil cooler
- Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Bolts
- Always replace after removing
- Tightening specification and sequence. Refer to .
- Electrical A/C Compressor -V470-
- Removing and installing. Refer to A/C COMPRESSOR .
- Electrical A/C Compressor -V470- Bolts
- There are different bolt lengths.
- Tightening specification. Refer to A/C COMPRESSOR .
- Replace the bolts that were tightened with an additional turn after removing them.
-- Mount the sub-assembly bracket and then install the bolts -4- first.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 5- | Install by hand all the way |
| 2. | -1 through 5- | 20 Nm |
| 3. | -1 through 5- | 90° additional turn |