Crankshaft, Measuring Radial Clearance: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2013 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Plastigauge®
- Use the old bolts for radial clearance measurement.
-- Remove the crankshaft bearing cap and clean the bearing cap and pin.
-- Place the Plastigauge® over the entire bearing width on the pin or in the bearing shells.
- Plastigauge® must rest in the center of the bearing shell.
-- Mount the crankshaft bearing cap and tighten with the old bolts -1 to 10- (refer to appropriate service information. ). Do not turn the crankshaft while doing so.
-- Remove the crankshaft bearing cap again.
-- Compare the width of Plastigauge® with the measuring scale.