Capacities, AUDI Q7 (4L_) From My 2006, AUDI Q7 (4M_) From My 2016
Audi Q7 (4L_) from MY 2006, Audi Q7 (4M_) from MY 2016
Features of the refrigerant system:
- Expansion Valve
- Depending on the vehicle equipment level with one or two evaporators
- Dryer cartridge in receiver/dryer on condenser
- "Denso" A/C compressor with A/C Compressor Regulator Valve -N280-. Refer to REFRIGERANT CIRCUIT
Audi Q7 e-tron (4M_) from MY 2016
- Expansion Valve
- An evaporator in the front heater and A/C unit
- Multiple change-over and check valves installed in the refrigerant circuit. Refer to REFRIGERANT CIRCUIT
- Additional heat exchangers installed in the refrigerant circuit. Refer to REFRIGERANT CIRCUIT
- Dryer cartridge in receiver/dryer on condenser
- Electrical A/C Compressor -V470- from the manufacturer "Sanden" with A/C Compressor Control Module -J842-. Refer to REFRIGERANT CIRCUIT
| Vehicle model | Production period | Capacity in grams | Differing features of this refrigerant circuit |
|---|---|---|---|
| Audi Q7 (4L_) | From 02/2006 | ||
|
700 + 50 |
|
|
|
1050 + 50 |
|
|
| Audi Q7 (4M_) | From 06/2015 | ||
|
700 + 15 |
|
|
|
950 + 15 |
|
|
| Audi Q7 e-tron (4M_) | From 02/2016 | 890 +/-15 |
|
On the Audi Q7 e-tron there are differences to the other vehicles additional components installed in the refrigerant circuit. For the layout of the different refrigerant circuits, refer to REFRIGERANT CIRCUIT
Due to the layout, the high pressure side service connection in the refrigerant circuit is located on the Audi Q7 e-tron on the high pressure side service connection only when operating the refrigerant circuit as a high pressure heat pump. In the A/C system operation the pressure is the same as on the low pressure side service connection.
To discharge, evacuate, and charge the refrigerant circuit on the Audi Q7 e-tron the valves installed in the refrigerant circuit which are power operated are opened. Activate and open the valves through a routine stored in the Thermal Management Control Module -J1024-. Refer to REFRIGERANT CIRCUIT (vehicle-specific repair information) and use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.