Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

When Installing The Ribbed Belt, Make Sure It Is Seated Correctly On The Pulleys.

Install in reverse order of removal. Note The Following:

-- Route the ribbed belt -2- in the specified sequence over the ribbed belt pulley.

1 - Generator

3 - Idler Roller

4 - Vibration damper

5 - Tensioning roller

-- Install the fan shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .

-- Start the engine and check the belt routing.