Overview - Crankshaft: Notes
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For Assembly Work, Secure The Engine On The Engine And Transmission Holder:VAS6095 . Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
Lubricate All Bearings And Running Surfaces.
- Cylinder Block
- Paired To -12-
- Sealant Applied On Cylinder Block (For Guide Frame). Refer To Figure
- Seals
- Always Replace
- Crankshaft Shaft Seal, Belt Pulley Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, BELT PULLEY SIDE .
- Alignment Sleeve
- Quantity: 2
- Insert Into Guide Frame
- Installed Position. Refer to Figure
- Bolt
- 9 Nm
- Oil Dipstick Tube
- O-Ring
- Always Replace
- Bolts
- Tightening Specification And Sequence. Refer To Figure.
- Always Replace
- For Guide Frame
- There Are Different Bolt Sizes
- Baffle Plate
- Bolt
- Tightening Specification And Sequence. Refer To Figure.
- Bolt
- For Guide Frame To Cylinder Block Sealing Surfaces
- There Are Different Bolt Lengths
- Tightening Sequence. Refer To Figure
- Guide Frame
- Paired To -1-.
- Sealant Applied On Cylinder Block (For Guide Frame). Refer To Figure
- Thrust Washer
- Only At The 4Th Crankshaft Bearing
- Installed Position: Lubricating Grooves Face Outward
- Note Locating Point In Guide Frame
- Bearing Shell
- For Guide Frame Without Lubricating Groove
- Always Replace If Removed
- Install The New Bearing Shells For The Guide Frame With The Correct Color Identification. Refer To MAIN BEARING SHELLS, NEW CRANKSHAFT, ALLOCATING . Refer to MAIN BEARING SHELLS, USED AND REWORKED CRANKSHAFTS, ALLOCATING
- Crankshaft
- Axial Play, Measuring. Refer To CRANKSHAFT, MEASURING AXIAL CLEARANCE .
- Radial Play, Measuring. Refer To CRANKSHAFT, MEASURING RADIAL CLEARANCE .
- Crankshaft Dimensions. Refer To CRANKSHAFT DIMENSIONS .
- Thrust Washer
- Only At The 4th Crankshaft Bearing
- Installed Position: Lubricating Grooves Face Outward
- Bearing Shell
- For Cylinder Block With Oil Groove
- Always Replace If Removed
- Install The New Bearing Shells For The Cylinder Block With The Correct Color Marking: New Crankshaft. Refer To MAIN BEARING SHELLS, NEW CRANKSHAFT, ALLOCATING , Worn Or Reworked Crankshaft. Refer To MAIN BEARING SHELLS, USED AND REWORKED CRANKSHAFTS, ALLOCATING
- Seals
- Always replace