Overview - Cylinder Head: Notes
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The illustration shows the Cylinder Bank 2 Cylinder Head (Left).
- Cylinder Head Gasket
- Replacing. Refer to LEFT CYLINDER HEAD, REMOVING or RIGHT CYLINDER HEAD, REMOVING
- Installing. Refer to CYLINDER HEAD, INSTALLING .
- Installed position: Parts number to cylinder head
- Change the coolant and engine oil after replacing
- Cylinder Head
- Removing. Refer to LEFT CYLINDER HEAD, REMOVING . Refer to RIGHT CYLINDER HEAD, REMOVING
- Installing. Refer to CYLINDER HEAD, INSTALLING .
- Check for distortion. Refer to Figure
- Reworking dimension. Refer to Figure
- Change the coolant and engine oil after replacing
- Cylinder Head Cover Gasket
- Replace if damaged or leaking
- Cylinder Head Cover
- Removing and installing. Refer to LEFT CYLINDER HEAD COVER, REMOVING AND INSTALLING . Refer to RIGHT CYLINDER HEAD COVER, REMOVING AND INSTALLING
- Seal
- For the cap
- Replace if damaged or leaking
- Cap
- Ignition Coil
- Remove with the Puller - Ignition Coil:T40039 .
- Bolt
- Camshaft Adjustment Valve 2 -N208-
- Bolt
- 2.4 Nm
- O-ring
- Always replace
- Seal
- Always replace
- Sealing Plug
- 35 Nm
- Bolt
- 2.4 Nm
- Exhaust Camshaft Adjustment Valve 2 -N318-
- O-ring
- Always replace
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Always replace
- Loosening sequence. Refer to LOOSEN THE CYLINDER HEAD BOLTS IN THE SEQUENCE -1 TO 10-.