Installation Location Of Front Bonded Rubber Bushing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Location Of Front Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

The grooves -arrows- point in direction of travel.

-A - Conventional bonded rubber bushing
-B - Hydraulic bonded rubber bushing

-- Place the tools on the front bonded rubber bushing as shown in the illustration.

Fig 2: Placing Tools On Front Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

Nut:T10263/5
Thrust piece:T40185/4
Subframe
Bonded rubber bushing or the hydraulic bonded rubber bushing
Thrust piece:T40185/3
Support ring:T10205/4
:VAS 6178
Nut:T10263/5
Spindle:T10263/4 . The spindle pins face downward.

-- Align the bonded rubber bushing with the markings made previously and push it in until the collar comes in contact with the bushing in the subframe >>without any gaps<<. If necessary, tension and press over cylinder several times. While pulling in, make sure the bonded rubber bushing does not cant, otherwise outer ring could be damaged.

-- The ends of the rubber bead on the bonded rubber bushing must align with the markings -arrows- on the subframe.

Fig 3: Ends Of Rubber Bead On Bonded Rubber Bushing Must Align With Markings

Courtesy of AUDI OF AMERICA, LLC

The illustration shows a hydraulic bonded rubber bushing. On a conventional bonded rubber bushing, the recesses on the rubber shoulders are turned 90°.

NOTE:

After replacing the bearing, fix any paint damage on the subframe with corrosion protection, primer and black top coat.

Further installation is in the reverse sequence to removal.