Wheel Bearing Housing Rubber Bonded Bushing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove wheel bearing housing. Refer To WHEEL BEARING HOUSING .

In order to remove the front rubber bonded bushing, the pressure plate:T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.

Fig 1: Front Rubber Bonded Bushing

Courtesy of AUDI OF AMERICA, LLC

-- Place the tools on the front bonded rubber bushing and the wheel bearing housing as illustrated.

Fig 2: Place Tools On Front Bonded Rubber Bushing And Wheel Bearing Housing As Illustrated

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When mounting the wheel bearing housing onto the sleeve:T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.

:VW 411
:T40184/2
Wheel bearing housing
:T40184/1 . The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the :T40184/1 .

-- Press out the front rubber bonded bushing.